These are High Volume Nitrogen Reservoir Replacement Endcaps from Schmidty Racing Suspensions to replace the OEM reservoir endcaps found on Walker Evans UTV and ATV shocks found on Polaris, Honda, Yamaha, Can-Am, Kawasaki, Arctic Cat, John Deere, etc models. These are designed to replace the OEM needle rubber nitrogen fill port style end caps that are found on new Walker Evans UTV shocks, which are hard to fill/check pressure & are unreliable. The OEM Walker Evan end caps that actually had schrader valves also had low quality, "low pressure" cores in them which are also very failure prone. Our Schmidty Racing Suspension replacement endcaps address all those issues!
Replacement Cap Features:
- Our endcaps have an actual schrader valve installed in them,& allows the shocks to be serviced and recharged using a standard no-loss chuck!
-The schrader valves on these endcaps are "recessed" into a pocket & have an o-ring based "schrader valve cap" which threads onto the schrader valve and seals it into the recessed pocket. This fully protects it from dirt, debris, mud, sand, etc!
-The schrader valve comes with a "high heat/pressure" Viton, schrader valve stem core for long term reliable service.
-These end caps also "increase" the nitrogen capacity of the reservoir. Shocks lose nitrogen over time and with use. By installing an end cap with a "larger volume", that "loss" will represent a smaller percentage of the total volume, and therefore keep the shock at, or near it's targeted pressure for a longer period of time, giving you better shock performance, for a longer period of time as well as extended service intervals.
-These reservoir caps are made from billet 6061 billet aluminum and have been black anodized then are engraved with our SRS logo. Each end cap also comes with a new o-ring for re-installing the replacement cap back into the shock reservoir, as well as instructions on how to install them.
Price is per/endcap. If you need more than one (1) reservoir endcap, simply enter the quantity you desire and place them in your cart.
To confirm which end cap size you need please measure the outside diameter of the shock reservoir.
2.0 Reservoir End Cap: 1.99"
2.5 Reservoir End Cap: 2.480"
Note: As stated these end caps replace the OEM Walker Evans Gen 2 2.0" and 2.5" Needle fill style end caps. Our High Volume Volume end cap will also fit the Gen 1 style 2.0" end cap with a Schrader valve and pin plier snap ring, but will need to select the Gen 1 option that includes a replacement snap ring. The Gen 2 2.5" High Volume end cap will not fit the Gen 1 2.5" reservoir.